1. Remove the old mirror and nut.
  2. Retain the original internal tooth lock-washer.
  3. Install new mirror stem through hand control assembly.
  4. Install flat washer on top and bottom of hand control assembly to stabilize mirror stem.
  5. Tighten to 8-12 ftlbs (10.8-16.3 Nm). Do not over-tighten. Check mirror adjustment and reposition if necessary.
NOTE:
Be sure wire existing mirror stem is positioned in wire guard so it does not get crushed by hardware.

 

KiWAV Axe LED turn signal black motorcycle mirrors for Harley Davidson