1. Clean and dry surface of gauge(2).
  2. Apply some double sided tape (not included) to trim ring(1).
  3. Before peeling off adhesive back, run and test fit by trim ring(1) onto gauge(2).
NOTE:Recommend to use 3M VHB double sided tape ( not included ).

 

KiWAV 5 inch Speedometer Trim Ring Visor cover aluminum matte black     KiWAV 5 inch Speedometer Trim Ring Visor cover aluminum chrome plated

  1. Remove the old mirror and nut. Retain the original internal tooth lock-washer.
  2. Install flat washer (1) on top of hand control assembly to stabilize mirror stem.
  3. Install new mirror stem through hand control assembly.
  4. Slide mirror power led wire (gray) through ground wire ring terminal (2) then install ring terminal on mirror stem.
  5. Slide mirror power lead wire (gray) through wire guard (3), then install wire guard on mirror stem.
  6. Install flat washer (4) from kit on mirror stem.
  7. Install acorn nut (5) on mirror stem.
  8. Tighten to 8-12 ft-lbs (10.8-16.3 Nm). Do not over-tighten.
  9. Check mirror adjustment and reposition if necessary.
NOTE:
Be sure wire exiting mirror stem is positioned in wire guard so it does not get crushed by hardware.

 

KiWAV FLASH LED turn signal mirrors chrome for Harley Davidson     KiWAV Axe led turn signal black motorcycle mirrors for Harley Davidson     Chrome rear view mirrors Palm 5/16 inch EMARK for Harley davidson

More mirrors for Harley Davidson >>
  1. Remove the old mirror assemblies from the bike.
  2. Install new mirror to hand control assembly (as Figure 1) with M6 allen key.
  3. Adjust the mirror for proper field of vision and tighten the part (1) (in Figure 2) with M2.5 allen key.
  4. Check mirror adjustment and reposition if necessary.

 

KiWAV tulip mirrors on motorcycle  Choose from 12 colors >>

 

Magazi Tulip red universal motorcycle scooter mirrors     Magazi motorcycle mirrors for scooter universal matte black     Magazi motorcycle mirrors for scooter universal blue

Check the video below to follow the step by step of the installation:
  1. Remove the old mirror and nut.
  2. Retain the original internal tooth lock-washer.
  3. Install new mirror stem through hand control assembly.
  4. Install flat washer on top and bottom of hand control assembly to stabilize mirror stem.
  5. Tighten to 8-12 ftlbs (10.8-16.3 Nm). Do not over-tighten. Check mirror adjustment and reposition if necessary.
NOTE:
Be sure wire existing mirror stem is positioned in wire guard so it does not get crushed by hardware.

 

KiWAV Axe LED turn signal black motorcycle mirrors for Harley Davidson

How to install a grip on your handlebar?

Here is a Video Tutorial for you!

How to install Magazi fog light mounting brackets on your motorcycle?

Here is a Video Tutorial for you!

How to install a Magazi Classic bar end mirrors on your motorcycle?

1. Remove the handlebar end-caps from your handlebars. Locate the handlebar weights. These weights must be partially or completely removed to install the bar-end mirror.
2. Insert the mirror mounting-system in the ends of the handlebars.

Here is a Video Tutorial for you!